Kramer-electronics VS-3232DN Manual de usuario descargar pdf (Pagina 37)

VS-3232DN - Using the Configuration Menus 33

To display a list of inputs that have detected signals:

1. Press MENU twice.

The following message is displayed:

start configuration menu

MENU to view setup ENT to change them

2. Press MENU.

The following is displayed:

IN: 01 02 03 04 05 06 07 08 09 10 11

SIG: Y X Y Y Y Y X Y Y Y X

 Y indicates that a signal is detected and X indicates that no signal is

detected on the relevant input.

3. Do one of the following:

 Press BREAKAWAY to exit the Config Menu

 Wait approximately 15 seconds for the operation to time out

 Press MENU to move to the next Config Menu option

8.2.2 Config Menu—Input Port Parameter Setting

This option sets input port specific parameters. Ports that show an X have no

parameters available to modify. Ports that show a 0 have parameters available to

modify. The parameters that are available, such as, audio balance, depend on the

type of card installed and whether the card is an input or an output card. Tables

listing input cards and their parameters can be found at the end of this section.

To set parameters for a port:

1. Press MENU twice.

The following message is displayed:

start configuration menu

MENU to view setup ENT to change them

2. Press MENU until a display similar to the following is shown:

IN: 01 02 03 04 05 06 07 08 09 10 11

SET: X X X X 0 0 0 0 X X X

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Sin comentarios

Kramer-electronics VS-3232DN Manual de usuario Pagina 37