Kramer-electronics VP-773AMP Manual de usuario descargar pdf (Pagina 27)

VP-773AMP - The OSD Menu

The display mode setup, shown in Figure 11, is part of the entire system control

and the selected Single Window also shows the current aspect ratio (Best Fit):

Figure 11: Select the Display Mode

6.2.1 Window Customization

Window customization lets you change the size and position of a selected window.

Make sure that you have control over the window that requires customization (Main

Window Control or PiP Window Control). If not, select it via the OSD item in the

Miscellaneous menu, see Section 6.8.

In the following examples, PiP Window Control is selected, but the same procedure

applies to Main Window Control.

Note that you can also customize the window size and position via the

“Y” commands (see Section 12.2) or protocol 3000 (see Section 12.4).

6.2.1.1 Changing the Size of the Main and/or PiP Window

Use the H Width and V Height to change the size of the window using the + and –

buttons on the front panel or remote control transmitter (as illustrated in Figure 12).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 79 80

Sin comentarios

Kramer-electronics VP-773AMP Manual de usuario Pagina 27