Kramer-electronics VM-4DP Manual de usuario descargar pdf (Pagina 11)

VM-4DP - Connecting the VM-4DP

5 Connecting the VM-4DP

Always switch off the power to each device before connecting it to your

VM-4DP. After connecting your VM-4DP, connect its power and then

switch on the power to each device.

To connect the VM-4DP as illustrated in the example in Figure 3:

1. Connect a DP source (for example, a computer graphics source) to the DP

INPUT connector.

2. Connect the DP output connectors (not all the outputs need to be

connected), to up to four DP acceptors (for example, displays).

3. Connect the power cord to the mains electricity (not shown in Figure 3).

4. Turn ON the POWER on the rear panel.

5. Acquire the EDID, see Section 6.

Figure 3: Connecting the VM-4DP 1:4 DisplayPort Distributor

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Kramer-electronics VM-4DP Manual de usuario Pagina 11