Kramer-electronics VP-747 Manual de usuario descargar pdf (Pagina 24)

VP-747 - Connecting the VP-747 Control Ports 19

6.3.1 Connect the VP-747 to the VP-747T by Wired Connection

To connect the VP-747 to the Kramer VP-747T Presentation Switcher Control Panel

via the 3-pin terminal block connector, as illustrated in

Figure 9, do the following:

• Connect the “A” PIN on the TO CONTROLLER mini XLR connector of the

VP-747 to the A (+) PIN on the RS-485 rear panel port of the VP-747T unit

• Connect the “B” (-) PIN on the TO CONTROLLER mini XLR connector of the

VP-747 to the B (-) PIN on the RS-485 rear panel port of the VP-747T unit

• If shielded twisted pair cable is used, the shield may be connected to the “G”

(Ground) PIN on one of the units

Figure 9: Connecting the VP-747 to the VP-747T

For the best results when working with the T-bar, we recommended

setting PROGRAM and PREVIEW to the same output resolutions

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 64 65

Sin comentarios

Kramer-electronics VP-747 Manual de usuario Pagina 24