Kramer-electronics VP-460 Manual de usuario descargar pdf (Pagina 13)

8 VP-460 - Connecting the VP-460

4 Connecting the VP-460

Always switch off the power to each device before connecting it to

your VP-460. After connecting your VP-460, connect its power and

then switch on the power to each device.

You do not have to connect all the inputs and outputs, connect only

those that are required.

To connect the VP-460, as illustrated in the example in

Figure 2, do the following:

1. Connect a computer graphics source to the PC IN VIDEO 15-pin HD INPUT

connector.

2. Connect a composite video source (for example, a composite video player)

to the CV IN VIDEO INPUT RCA connector.

3. Connect an SDI source (for example, an SDI digital camera) to the SDI IN

VIDEO INPUT BNC connector.

4. Connect the audio input signals to the AUDIO IN connectors: PC IN (3.5mm

mini jack) and CV IN (RCA connectors), as required (not shown in

Figure 2).

5. Connect the HDMI OUT connector to an HDMI acceptor (for example, a

plasma display).

6. Connect the SDI LOOP BNC connector to an SDI monitor (for example, an

SDI display).

7. Connect the SDI OUT BNC connector to an SDI acceptor (for example, an

SDI display with speakers).

8. Connect the S/PDIF OUT RCA connector to an audio acceptor (for example,

a receiver), not shown in

Figure 2.

9. If required, you can connect a PC and/or controller to the RS-232 terminal

block (see

Section 7.2.1

)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 60 61

Sin comentarios

Kramer-electronics VP-460 Manual de usuario Pagina 13