Kramer-electronics PL-8 Manual de usuario descargar pdf (Pagina 15)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Kramer Protocol15F

Figure 13: Atmel – Flip Window (Operation Completed)

10. Close the “Atmel – Flip” window.

11. Disconnect the power on the PL-8.

12. If required, disconnect the RS-232 terminal block connector on the PL-8

unit from the Null-modem adapter.

13. Slide the underside PROGRAM switch back to normal.

14. Connect the power to the PL-8.

7 Kramer Protocol

By default, the PL-8 is set to protocol 3000 (see section

7.1) but is also

compatible with Kramer’s Protocol 2000 (see section 7.2).

You can switch protocols by setting DIP-switch 8 OFF for protocol 3000 and

ON for protocol 2000.

7.1 PL-8 Commands in Protocol 2000

This RS-232/RS-485 communication protocol uses four bytes of information

as defined below. For RS-232, a null-modem connection between the

machine and controller is used. The default data rate is 9600 baud, with no

parity, 8 data bits and 1 stop bit.

1 You can download our user-friendly “Software for Calculating Hex Codes for Pr otocol 2000” from the technical support

section on our Web site at: http://www.kramerelectronics.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

Kramer-electronics PL-8 Manual de usuario Pagina 15