Kramer-electronics FC-24ETH Manual de usuario descargar pdf (Pagina 37)

Configuring and Maintaining the FC-21ETH,

FC-22ETH and FC-24ETH

8 Configuring and Maintaining the FC-21ETH,

FC-22ETH and FC-24ETH

This section describes:

 Selecting the RS-232 or RS-485 Port (see Section 8.1)

 Terminating the RS-485 bus (see Section 8.2)

 Activating DHCP (see Section 8.3)

 Resetting to the factory default settings (see Section 8.4)

 Upgrading the firmware (see Section 8.5)

8.1 Selecting the RS-232 or RS-485 Serial Port

The 3-pin Serial terminal block can be used as either an RS-232 or as an RS-485

port.

To set the Serial port as an RS-232 port:

 Release the RS-232/RS-485 button on the rear panel.

The Serial RS-232 LED lights

To set the Serial port as an RS-485 port:

 Depress the RS-232/RS-485 button on the rear panel.

The Serial RS-485 LED lights

8.2 Terminating the RS-485 Bus

The devices at both ends of the RS-485 chain must be terminated; all other

devices in the chain must be left unterminated.

To terminate the RS-485 bus:

 Slide the RS-485 Term switch down

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 46 47

Sin comentarios

Kramer-electronics FC-24ETH Manual de usuario Pagina 37