Kramer Electronics 840HXL Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 31
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
840Hxl - Serial Protocol 23
23
8.3 Commands
The commands listed below are supported by the 840Hxl.
Note: A checksum is required at the end of the send/receive command as shown
in
Section 8.1
8.3.1 Get Device Address and Software Version
. If a checksum is not included in a sent command, the device does
not respond.
Command Send/Receive Data
0x00
0xEB, 0x00, 0x00, 0x01, 0xXX, checksum
0xEB, [address], 0x00, 0x02, [version],
0x00, checksum
0xXX can be any data except 0xEB
8.3.2 Set Output Encryption or Decryption
Command Send/Receive Data
0xE3 0xEB, 0x00, 0xE3, 0x01, data 1,
checksum
0xEB, address, 0xE3, 0x01, 0xFA,
checksum
data1:
0 = encryption
1 = decryption
8.3.3 Get Device Status
Command Send/Receive Data
0xE4 0xEB, address, 0xE4, 0x01, 0x00,
checksum
0xEB, address, 0xE4, 0x08, data1, .....,
data8, checksum
data1: reserved
data2: reserved
data3: output encryption status:
0 = encryption
1 = decryption
data4: reserved
data5: reserved
data6: reserved
data7: reserved
data8: reserved
8.3.4 Set Output Status
Command Send/Receive Data
0xE6 0xEB, address, 0xE6, 0x02, data1, data2,
checksum
0xEB, address, 0xE6, 0x01, 0xFA,
checksum
data 1:
0x00: reserved
0x01: RESOLUTION_INDEX
0x02: PATTERN_INDEX
0x03: DEEPCOLOR_MODE
0x04: COLORSPACE_MODE
0x05:HDMIDVI_INDEX
0x06: AUDSAMPLE_INDEX
0x07: AUDBIT_INDEX
data 2:
0x00 reserved
from 0x00 to 0x17 (24 resolutions)
from 0x00 to 0x1f (32 patterns)
0 = auto, 0x18 = 24bit, 0x1e = 30bit, 0x24 = 36bit
0 = auto, 1 = RGB444, 2 = YUV444, 3 = YUV422
0 = auto, 1 = HDMI, 2 = DVI
0 = auto, 1 = 44k, 2 = 48k 3 = 88k, 4 = 96k, 5 =
176k, 6 = 192k
0 = auto, 0x10 = 16bit, 0x14 = 20bit, 0x18 = 24bit
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31

Comentarios a estos manuales

Sin comentarios