Kramer-electronics VM-100CA Manual de usuario descargar pdf (Pagina 11)

Connecting the VM-100CA

6.2 Connecting Several VM-100CA Units

You can connect several VM-100CA units to form an expanded video

component / audio distributor. For example, as Figure 5 illustrates

, connect

two VM-100CA units to form a 1:20 video component / audio distributor.

To connect several VM-100CA units, do the following

1. Connect a component video source to the COMPONENT VIDEO INPUT

RCA connectors on the first VM-100CA unit.

2. Connect the COMPONENT VIDEO LOOP RCA connectors on the first

VM-100CA unit to the COMPONENT VIDEO INPUT RCA connectors

on the second VM-100CA unit.

3. Release the Input Term button to Hi-Z on the first VM-100CA unit, and

push in the Input Term button to 75 on the second VM-100CA unit

4. Connect the COMPONENT VIDEO OUT connectors

, as follows:

 On the first VM-100CA unit, to component video acceptors 1 to 10

 On the second VM-100CA unit, to component video acceptors 11 to 20

5. Connect both power cords (not illustrated in Figure 5).

Figure 5: Connecting Several VM-100CA Units

1 Audio connections are not shown in this example

2 Switch OFF the power on each device before connecting it to a VM-100CA unit. After connecting all VM-100CA units,

switch on their power and then switch on the power on each device

3 In general, when looping, the Input Term button should be set for Hi-Z for all units except for the last one in the chain

4 When less than the maximum outputs are required, connect only those outputs that are required, and leave the other outputs

unconnected

1 2 ... 6 7 8 9 10 11 12 13 14

Sin comentarios

Kramer-electronics VM-100CA Manual de usuario Pagina 11