Kramer-electronics VM-5S Manual de usuario descargar pdf (Pagina 19)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Connecting the Distributors

5.5 Connecting the VM-50YC 1:5 s-Video Distributor

To connect the VM-50YC, as shown in

Figure 10, do the following

1. Connect the input video source (for example, an s-video player) to the

INPUT IN s-video connector.

2. If looping the input to another device, connect a video acceptor (for example

an s-video monitor) to the INPUT LOOP s-video connector.

3. If the input loop is not used, press IN the TERM pushbutton to add a 75Ω

termination to the line. If an input loop is used, release the TERM

pushbutton.

4. Connect the OUTPUTS 1 to 5 s-video connectors to up to 5 acceptors

5. Connect the 12V DC power supply to the unit (not shown in the illustration)

and then to the mains electricity. Switch on the power.

(for

example, s-video recorders).

Figure 10: Connecting the VM-50YC 1:5 s-Video Distributor

1 Switch OFF the power on each device before connecting it to your VM-50YC. After connecting, switch on the VM-50YC

power and then switch on the power on each device

2 You are not required to connect all the acceptors

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Kramer-electronics VM-5S Manual de usuario Pagina 19