Kramer Electronics VA-2002 Manual de usuario descargar pdf (Pagina 10)

Connecting the VA-2002 Multistandard Logo Generator

6 Connecting the VA-2002 Multistandard Logo Generator

To connect the VA-2002 Multistandard Logo Generator as the example in

Figure 2 illustrates, do the following

1. Connect a composite video source (for example, a composite video VCR) to

the CV BNC INPUT connector.

2. Connect an s-Video source (for example, an s-Video S-VHS) to the Y/C 4p

INPUT connector.

3. Connect the CV BNC OUTPUT connector to a composite video acceptor (for

example, a composite video recorder).

4. Connect the Y/C 4p OUTPUT connector to an s-Video acceptor (for example,

an s-Video projector).

5. Connect the CV BNC MONITOR connector to a composite video acceptor

(for example, a display).

6. Connect the Y/C 4p MONITOR connector to an s-Video acceptor (for

example, a display).

7. Connect the power cord (not shown in Figure 2).

8. If required, connect a PC

for use with the VA-2002 Remote Control program

that lets you remotely transfer a logo to the VA-2002 via RS-232, as well as

control certain functions

and verify information

, as section 9.1 describes.

1 Switch OFF the power on each device before connecting it to your VA-2002. After connecting your VA-2002, switch on its

power and then switch on the power on each device

2 Use a flat-cable (that is, one-to-one uncrossed connections) without a null-modem adapter to connect the RS-232 DB9 port

on your PC to the RS-232F DB9 rear panel port on the VA-2002

3 That is, turn a logo On or Off, as well as delete a logo or all the logos simultaneously

4 That is, memory, size, system information, and version number

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Sin comentarios

Kramer Electronics VA-2002 Manual de usuario Pagina 10