Kramer-electronics VP-730 Manual de usuario descargar pdf (Pagina 15)

10 VP-730 - Connecting the VP-730

5 Connecting the VP-730

Always switch off the power to each device before connecting it to your

VP-730. After connecting your VP-730, connect its power and then

switch on the power to each device.

To connect the VP-730 as illustrated in the example in

Figure 3, do the following:

1. Connect the video sources:

 A component video source (for example, a DVD player) to the

UNIV. IN 1 RCA connectors, Y/CV, Pb/C and Pr

Component video is sometimes called YUV, or Y, B-Y, R-Y

 A composite source (for example, a DVD player) to the UNIV. IN 2

RCA connector

 A computer graphics source to the PC 1 IN 15-pin HD computer

graphics video connector

 An HDMI source (for example, a DVD player) to the HDMI 1 IN

connector

 A graphics data source (for example, JPEG files that should be smaller

than 1MB and should not exceed a resolution of 2048x1536, from a

PC or a USB flash drive) to the USB connector on the front panel of

the machine

2. Connect the balanced stereo audio sources, that is, the audio of:

 Component video source 1 to the AUDIO UNIV. IN 1 terminal block

 Composite video source to the AUDIO UNIV. IN 2 terminal block

 Computer graphics source to the AUDIO PC 1 terminal block

Although this connecting example shows only several inputs that are

connected, you can connect all the inputs simultaneously.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Sin comentarios

Kramer-electronics VP-730 Manual de usuario Pagina 15