Kramer-electronics RC-78R Manual de usuario descargar pdf (Pagina 12)

RC-76R/RC-78R - Connecting the RC-76R/RC-78R

 Connect the A (+) pin of the device to the A pin on the RS-485 terminal block

of the RC-76R/RC-78R

 Connect the B (-) pin of the device to the B pin on the RS-485 terminal block of

the RC-76R/RC-78R

 Connect the G pin of the device to the GND pin on the RS-485 terminal block

of the RC-76R/RC-78R

If your device is the first or last device on the line, slide the RS-485 termination

switch up otherwise make sure it is set to down (see Figure 1).

4.3 Connecting the Ethernet Port

The Ethernet connection of the RC-76R/RC-78R lets you perform all control

functions of the RC-76R/RC-78R over the Internet using a PC running the Kramer

Site-CTRL control program to control AV devices.

To connect the RC-76R/RC-78R to a network:

1. Connect the Ethernet port of the RC-76R/RC-78R to the Ethernet port on a

network hub or network router, via a straight cable with RJ-45 connectors.

2. At the other end, connect the Internet to a PC running Site-CTRL.

3. After connecting the Ethernet port, you have to install and configure it. For

detailed instructions on how to install and configure your Ethernet port, see

the K-Config Software Guide.

Available from our Web site at http://www.kramerelectronics.com.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Sin comentarios

Kramer-electronics RC-78R Manual de usuario Pagina 12