Kramer-electronics RC-76M Manual de usuario descargar pdf (Pagina 15)

RC-76M/ RC-712M - Installing the RC-76M/RC-712M

4.4 Connecting the K-NET Port

The K-NET port is wired as shown in Figure 5.

If your device is the first or last

device on the line, slide the

K-NET termination switch up;

otherwise make sure it is set to

down (see Figure 1).

Figure 5: K-NET PINOUT Connection

4.5 Mounting the RC-76M/RC-712M onto the Merten Housing

After the cables are connected you can mount the device onto the housing. Note

that the illustrations in this section do not show the cables that are already

connected to the device and passing through the housing cable openings.

To mount the RC-76M/RC-712M:

1. Reconnect the detachable terminals to the rear panel

2. Gently place the RC-76M/RC-712M inside the housing, making sure that all

cables remain connected.

Figure 6: Inserting the RC-76M/RC-712M

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

Sin comentarios

Kramer-electronics RC-76M Manual de usuario Pagina 15